|Buy sheetmusic at SheetMusicPlus|
Hearing is not a purely mechanical phenomenon of wave propagation, but is also a sensory and perceptual event. When a person hears something, that something arrives at the ear as a mechanical sound wave traveling through the air, but within the ear it is transformed into neural action potentials. These nerve pulses then travel to the brain where they are perceived. Hence, in many problems in acoustics, such as for audio processing, it is advantageous to take into account not just the mechanics of the environment, but also the fact that both the ear and the brain are involved in a person’s listening experience.
The inner ear, for example, does significant signal processing in converting sound waveforms into neural stimulus, so certain differences between waveforms may be imperceptible. Audio compression techniques, such as MP3, make use of this fact. In addition, the ear has a nonlinear response to sounds of different loudness levels. Telephone networks and audio noise reduction systems make use of this fact by nonlinearly compressing data samples before transmission, and then expanding them for playback. Another effect of the ear's nonlinear response is that sounds that are close in frequency produce phantom beat notes, or intermodulation distortion products.
Limits of perception
The human ear can nominally hear sounds in the range 20 Hz to 20,000 Hz (20 kHz). This upper limit tends to decrease with age, most adults being unable to hear above 16 kHz. The ear itself does not respond to frequencies below 20 Hz, but these can be perceived via the body's sense of touch.
Frequency resolution of the ear is 3.6 Hz within the octave of 1,000–2,000 Hz. That is, changes in pitch larger than 3.6 Hz can be perceived in a clinical setting. However, even smaller pitch differences can be perceived through other means. For example, the interference of two pitches can often be heard as a (low-)frequency difference pitch. This effect of phase variance upon the resultant sound is known as beating.
The semitone scale used in Western musical notation is not a linear frequency scale but logarithmic. Other scales have been derived directly from experiments on human hearing perception, such as the mel scale and Bark scale (these are used in studying perception, but not usually in musical composition), and these are approximately logarithmic in frequency at the high-frequency end, but nearly linear at the low-frequency end.
The intensity range of audible sounds is enormous. Our ear drums are sensitive only to variations in the sound pressure, but can detect pressure changes as small as 2×10−10 atm and as great as or greater than 1 atm. For this reason, sound pressure level is also measured logarithmically, with all pressures referenced to 1.97385×10−10 atm. The lower limit of audibility is therefore defined as 0 dB, but the upper limit is not as clearly defined. The upper limit is more a question of the limit where the ear will be physically harmed or with the potential to cause noise-induced hearing loss.
A more rigorous exploration of the lower limits of audibility determines that the minimum threshold at which a sound can be heard is frequency dependent. By measuring this minimum intensity for testing tones of various frequencies, a frequency dependent absolute threshold of hearing (ATH) curve may be derived. Typically, the ear shows a peak of sensitivity (i.e., its lowest ATH) between 1 kHz and 5 kHz, though the threshold changes with age, with older ears showing decreased sensitivity above 2 kHz.
The ATH is the lowest of the equal-loudness contours. Equal-loudness contours indicate the sound pressure level (dB), over the range of audible frequencies, which are perceived as being of equal loudness. Equal-loudness contours were first measured by Fletcher and Munson at Bell Labs in 1933 using pure tones reproduced via headphones, and the data they collected are called Fletcher-Munson curves. Because subjective loudness was difficult to measure, the Fletcher-Munson curves were averaged over many subjects.
Robinson and Dadson refined the process in 1956 to obtain a new set of equal-loudness curves for a frontal sound source measured in an anechoic chamber. The Robinson-Dadson curves were standardized as ISO 226 in 1986. In 2003, ISO 226 was revised as equal-loudness contour using data collected from 12 international studies.
In some situations an otherwise clearly audible sound can be masked by another sound. For example, conversation at a bus stop can be completely impossible if a loud bus is driving past. This phenomenon is called masking. A weaker sound is masked if it is made inaudible in the presence of a louder sound.
A harmonic series of pitches that are related 2×f, 3×f, 4×f, 5×f, etc., give human hearing the psychoacoustic impression that the pitch 1×f is present.
The psychoacoustic model provides for high quality lossy signal compression by describing which parts of a given digital audio signal can be removed (or aggressively compressed) safely - that is, without significant losses in the (consciously) perceived quality of the sound.
It can explain how a sharp clap of the hands might seem painfully loud in a quiet library, but is hardly noticeable after a car backfires on a busy, urban street. This provides great benefit to the overall compression ratio, and psychoacoustic analysis routinely leads to compressed music files that are 1/10 to 1/12 the size of high quality masters with very little discernible loss in quality. Such compression is a feature of nearly all modern audio compression formats. Some of these formats include MP3, Ogg Vorbis, AAC, WMA, MPEG-1 Layer II (used for digital audio broadcasting in several countries) and ATRAC, the compression used in MiniDisc and some Walkman models.
Psychoacoustics is based heavily on human anatomy, especially the ear's limitations in perceiving sound as outlined previously. To summarize, these limitations are:
Given that the ear will not be at peak perceptive capacity when dealing with these limitations, a compression algorithm can assign a lower priority to sounds outside the range of human hearing. By carefully shifting bits away from the unimportant components and toward the important ones, the algorithm ensures that the sounds a listener is most likely to perceive are of the highest quality.
Psychoacoustics include topics and studies which are relevant to music psychology and music therapy. Theorists such as Benjamin Boretz consider some of the results of psychoacoustics to be meaningful only in a musical context.
Psychoacoustics is presently applied within many fields from software development, where developers map proven and experimental mathematical patterns; in digital signal processing, where many audio compression codecs such as MP3 use a psychoacoustic model to increase compression ratios; in the design of (high end) audio systems for accurate reproduction of music in theatres and homes; as well as defense systems where scientists have experimented with limited success in creating new acoustic weapons, which emit frequencies that may impair, harm, or kill (see ). It is also applied today within music, where musicians and artists continue to create new auditory experiences by masking unwanted frequencies of instruments, causing other frequencies to be enhanced. Yet another application is in design of small or lower-quality loudspeakers, which use the phenomenon of missing fundamentals to give the effect of low frequency bass notes that the system, due to frequency limitations, cannot actually reproduce (see references).
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article "Psychoacoustic". Allthough most Wikipedia articles provide accurate information accuracy can not be guaranteed.
Beethoven, L. van
6 Ecossaises for Piano in E flat major
Symphony No. 1 in B flat "Spring"
L'Orchestre de la Suisse Romande
Ave verum corpus
Corale San Gaudenzio
Concerto for 2 violins in D minor